MPS 800 Gateway Kit Installation
2
1
Use the rear panel power switch to
switch off the MPS power.
Insert the new Gateway board
into the first available slot in the front panel.
3
5
4
Connect a LAN cable from the Ethernet socket
of the board just installed and to your network.
Turn the MPS power back on.
Send the MPS serial No. to your TANDBERG
Representative. You will then receive the
option key needed to activate the new
boards.
6
Access the TANDBERG MPS by entering
the IP-address of the Gateway Board in
a standard web browser to complete the
configuration of the new Gateway Board and
upload the new Gateway option keys. See the
below Fig. and the MPS User Manual for more
information.
The system is ready for configuration once the
Power and the Active LED are green and the initial
configuration menu appears on the LCD.
Click the Restart button.
7
D13903.02
|
Sharp Microwave Oven R 1500 User Manual
Sharp Projector XG PH50X User Manual
Sharp Refrigerator SJ FP813V User Manual
Shindaiwa Trimmer AHS2510 EVC User Manual
Snapper Lawn Mower Accessory 1695163 User Manual
Sony Home Theater System 3 299 270 212 User Manual
State Industries Water Heater 184671 000 Rear User Manual
Sterling Plumbing Marine Sanitation System SCC4 38 User Manual
Sylvania TV VCR Combo 6313CD User Manual
Targus Mouse AKM10US User Manual